System Status

---

The first screen displayed after Logging In is the System Status screen. You can always return to this screen by clicking the Status button.

Figure 3-1 System Status Screen

The System Status screen provides the following information:

System Status: This area provides system-level information, including the unit's IP address and contact information. See System for information on these settings.
System Alarms: System traps (if any) appear in this area. Each trap identifies a specific severity level: critical, major, minor, and informational. See Alarms for a list of possible alarms.
NOTE: On APs with model numbers ending in -WD, -EU, or -UK, if an operating Country has not been selected (during the Setup Wizard or on the Configure > System tab), an informational message will appear in the System Alarms list, and you will be unable to configure interface parameters.

From this screen, you can also access the AP's monitoring and configuration options by clicking on the buttons on the left of the screen.